www.vbs-hobby.com 
Exclusive offersChristmas money gifts
Instructions No. 2936 Instructions No. 2936 Difficulty: Beginner Working time: 4 Hours
Transform simple materials into enchanting angels and create original Christmas gifts for your loved ones. With just a few simple steps, you can create personal works of art that will go down very well as gifts.
To create the angels, start by cutting vellum paper for small messages. You can first write personal messages on them and then roll them up. Carefully place each roll in the test tube. This way the contents will be hidden at first.
Tie about 30 cm of enamelled copper wire around the centre of the angel wings. Put some hot glue in the middle and press the test tube onto it. Then wrap the wire around the test tube and twist the ends.
Cut a banner out of the vellum paper and stamp with the stamp set XL "Christmas Wishes" and the waterproof ink pads "Staz-On". Use a hole punch to punch a small hole and pull the wire through the banner. Wrap the remaining wire around a bamboo skewer to make a pretty spiral.
For the trio of hats, print out the template and then cut out the shapes. Transfer them to craft felt with a sublimation pen and cut out the individual hats. Glue each beard onto the test tube with VBS handicraft glue and place the wooden hemisphere on top.
Cut the vellum paper, roll it up and put it into the tube. Finally, pull the cap over the cork.
Tie about 30 cm of enamelled copper wire around the centre of the angel wings. Put some hot glue in the middle and press the test tube onto it. Then wrap the wire around the test tube and twist the ends.
Cut a banner out of the vellum paper and stamp with the stamp set XL "Christmas Wishes" and the waterproof ink pads "Staz-On". Use a hole punch to punch a small hole and pull the wire through the banner. Wrap the remaining wire around a bamboo skewer to make a pretty spiral.
For the trio of hats, print out the template and then cut out the shapes. Transfer them to craft felt with a sublimation pen and cut out the individual hats. Glue each beard onto the test tube with VBS handicraft glue and place the wooden hemisphere on top.
Cut the vellum paper, roll it up and put it into the tube. Finally, pull the cap over the cork.
