Pata'Mould kneading silicone

With Pata'Mould kneading silicone , impressions and impressions of all kinds of objects and materials can be made. You will receive 80 g of the kneading silicone.

With Pata'Mould impressions and impressions of objects of all kinds of materials can be made. For this purpose, "Pata" and "Mould" are each kneaded in equal proportions (50/50) until a homogeneous, light blue mass is obtained.

The kneading mass is applied to the model in a layer at least 2 mm thick. Make sure that no air bubbles form under the silicone. After a total of approx. 10 minutes of drying, your mould is ready. The finished kneading silicone mould can be filled with all modelling and casting compounds.

The finished mould can be filled with all modelling and casting compounds . Up to 50 impressions are possible, depending on the casting compound or Modelling clay used.
Produces a milk glass effect during resin application.

Tip: Place in the refrigerator a few hours before processing to prolong the reaction time.